Your Best Choice for Furnace, Heat Pump, & AC Repair in Sturtevant, WI

Package unit maintenance. System is cooling and heating well with no issues to report!

Performed Furnace Tune up, system is running and heating well!

Performed a boiler tune up on a Peerless boiler. She’s working fine.

Magic-pak tune up. Checked thermostat and verified operation, inspected heat exchanger, checked inducer, blower, compressor, and condenser fan motor amperage, cleared drain line, cleaned flame sensor and sparking rods, checked air filter, checked temperature rise and drop, checked all wire and electrical connections, checked gas pressure, checked capacitors, checked contactor, verified refrigerant levels, cleaned condenser coil and unit.
System is both cooling and heating well!

Re-installed an Ecobee-pro thermostat after it was found to be hanging of the wall and help clients connect to Ecobee pro.

Clogged drain lines on a magic pack unit.

Trane A/C & furnace tune up.

Furnace is running and heating properly with no issues to report. Cleared pressure switch tubing and cleaned flame sensor (see attached documents for more details)

furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Bryant equipment install quality check. System is cooling and heating well with no issues to report.

Bryant ac noise inspection. Made adjustments to lineset mounts, compressor mounts, and added rubber noise pads underneath condenser. System is now a bit quieter with no issues to report

Package tuneup. System is heating and cooling in a safe and efficient manner with no issues to report

Performed AC diagnostic, bad capacitor and low on r-22

Performed AC diagnostic, system was plugged and low on refrigerant. Cleaned outdoor unit and changed filter. Also filled up with 410a and added leak lock.

ac tuneup, maintenance, and inspection. Checked thermostat, checked air filter, checked blower, fan, and compressor amperage, checked temperature levels, checked refrigerant levels, checked capacitor, cleared drain line, cleaned condenser coils, checked contactor and all electrical connections, and verified unit

Bryant ac inspection and quality check after a recent install. Made minor airflow and thermostat adjustments. System is running and cooling well with no issues to report!

Performed Bryant ac installation. Configured all system settings to relate to customer's specific home needs. Tested system and ensured all proper functions. System is running and cooling well!

Upon arrival made call for cooling. Verified blower operation and went outside to find unit was running but buzzing loudly. Turned off at disconnect and checked AC cabinet. Tested 45/5 capacitor herm side tested 0 fan tested good at 5. Replaced bad capacitor and returned power to outdoor unit, fired right up. Unit has since stopped buzzing and is fully operational. Contactor in good condition. Suction PSI 115 Liquid PSI 250 ODT 71.7° Today’s visit and part paid for card. Customer signed up for gold plan during today’s visit.

Bryant ac inspection. System is running and cooling well with no issues to report!

Upon arrival unit was not turning on. Found portable AC was plugged into a power strip. This should always be plugged into a wall receptacle, never a power strip. Because of this, it tripped the breaker. Reset breaker and unit fired up no issues. Left original portable AC in place as it does work fine.

Upon arrival outdoor unit was not getting 240VAC. Checked disconnect and found power was not present there either. Went to basement to inspect breaker panel. Reset breaker but did not hear any compressor noise. Reset a second time and heard the compressor start up. Went outside and verified power was now present. Unit was running and blowing hot air as it should. Informed customer her compressor is starting to fail and overamping. We could throw a hard start kit to possibly buy some time or replace compressor or replace outdoor unit. She would like a quote before making any decision. Office will call to schedule quote for replacement AC.

Installed a portable ac unit for an elderly customer to give a temporary source of cooling while customer waits for replacement parts

Carrier ac intermittently freezing due to a stuck txv. Part is ordered and we are rescheduled for replacement

Just completed an install quality check on a Bryant single stage system we installed, the guys did a great job and the customer is happy!

Armstrong Air A/C tuneup, maintenance, and inspection. Checked thermostat, checked air filter, checked blower, fan, and compressor amperage, checked temperature levels, checked refrigerant levels, checked capacitor, cleared drain line, cleaned condenser coils, checked contactor and all electrical connections, and verified unit operation. System running and cooling well!/C tuneup, maintenance, and inspection. Checked thermostat, checked air filter, checked blower, fan, and compressor amperage, checked temperature levels, checked refrigerant levels, checked capacitor, cleared drain line, cleaned condenser coils, checked contactor and all electrical connections, and verified unit operation. System running and cooling well!