Your Best Choice for Furnace, Heat Pump, & AC Repair in Salem, WI

Upon arrival checked furnace filter and verified it was completely black. Verified 2 heating cycles and was not able to find any reason the furnace would cause the filter to get so dirty. Homeowner claims to change filter every two months, but this appeared to be almost a year without change. Was not able to determine due to no date on the filter itself. Cleaned flame sensor and drain trap during today’s visit. Rest of furnace appears clean and fully operational.

Rheem Furnace is running and heating properly with no issues to report. Cleaned out mouse nesting from upper inside furnace cabinet. Unit is now clean. Cleared pressure switch tubing and cleaned flame sensor (see attached documents for more details).

Bryant Furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Ac tune up Cleared drain line and fitting at inside coil Delta T ( temp drop ) Amp draw on blower, outdoor fan motor, and compressor Checked capacitor Refrigerant levels ok Outside unit clean Recommend yearly maintenance to prolong equipment life

Heil furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Replaced capacitor in geothermal unit. Geothermal is running and heating good at this time.

Completed tune up on geothermal. Cleaned and checked essentials as needed. Unit is running and heating good at this time.

Just performed a furnace tune up on a trane high efficiency furnace

Just performed a furnace tune up on a Bryant high efficiency furnace

Just performed a tune up on a trane air conditioner

Replaced a cracked condensate trap and mounting bracket on a Rheem Classic 90 Plus furnace. No more leaks!

Water around furnace. Found cracked condensate trap.

Just performed a furnace tune up on a trane high efficiency furnace

Magic pack check in: Magic pack tuneup, maintenance, and inspection. Checked thermostat and verified operation, inspected heat exchanger, checked inducer, blower, compressor, and condenser fan motor amperage, cleared drain line, cleaned flame sensor and sparking rods, checked air filter, checked temperature rise and drop, checked all wire and electrical connections, checked gas pressure, checked capacitors, checked contactor, verified refrigerant levels, cleaned condenser coil and unit. System running, cooling, and heating well!

Removed jumper for w1 and w2. Changed inducer motor and tested operations. Changed airflow to higher cfm by sw1-4. Adding 10% cfm. Unit kicks on in low if thermostat set just above setpoint otherwise will kick onto high stage. Both stages working fine at this tome. 1.5/3.4” wc

Just performed a maintenance on a weather king air conditioner

Bryant ac tuneup, maintenance, and inspection. Checked thermostat, checked air filter, checked blower, fan, and compressor amperage, checked temperature levels, checked refrigerant levels, checked capacitor, cleared drain line, cleaned condenser coils, checked contactor and all electrical connections, and verified unit operation. System running and cooling well!

Goodman furnace repair

Heil furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Water furnace geothermal tuneup, maintenance, and inspection. system running to factory specs, checked temperature readings of air flow and water, checked water loop pressures and added water, checked blower capacitor in spec, checked all wire and electrical connections, cleaned air filter, cleaned unit, checked all motor amp draws, verified system operation. System is running well with no issues to report

Installed new Bryant high efficiency furnace

Rheem furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Quoted customer a 2 stage variable speed furnace with smart thermostat.

Trane furnace tuneup, maintenance, and inspection. Checked thermostat, cleaned condensate trap, checked air filter, cleared drain lines, cleaned flame sensor, checked igniter, inspected burners and heat exchanger, checked and cleaned intake pipe, checked blower and inducer motor amps, checked and adjusted gas pressure, checked all wire and electrical connections, checked temperature rise, and cleaned unit. System running and heating well!

Just performed a maintenance on a American standard air conditioner

Customer require 24 hour emergency service on Heil gas furnace. Found drain line plugged.

Just completed a tune up on a Bryant air conditioner, checked all mechanicals everything is running great!

Heil ac tuneup, maintenance, and inspection. Checked thermostat, checked air filter, checked blower, fan, and compressor amperage, checked temperature levels, checked refrigerant levels, checked capacitor, cleared drain line, cleaned condenser coils, checked contactor and all electrical connections, and verified unit operation. System running and cooling well!

Quoted customer a new AC system.

Inspection of ductwork, found disconnect supply pipe to upstairs of home, added information, pictures, and measurements to give estimate. Customer also joined annual preventative maintenance plan with First Call heating and cooling and is already prescheduled for a future ac tuneup.

Just worked on a tempstar furnace

Furnace repair service and installation

Just completed a maintenance agreement furnace tune up on a Trane XC95m, Checked thermostat and verified operation, checked air filter, checked intake pipe, cleaned drain trap, cleaned flame sensor, cleared drain line, checked ohms on the igniter, inspected heat exchanger, checked amperage on blower and inducer motor, checked gas pressure low and high fire, took a temperature reading on return and supply, checked all wires, cleaned unit, everything is running great!

Tempstar furnace repair inspection maintenance tuneup replacement

Rheem furnace repair inspection maintenance tuneup replacement

Quoted customer a new air handler with AC system.

Customer bough a new AC system.

Quoted customer a modulating furnace with variable speed blower motor and 16 seer AC system.

Trane ac repair inspection maintenance tuneup replacement

Installation of kenmore furnace and air conditioner

Installation of kenmore furnace and air conditioner

Installation of kenmore furnace and air conditioner

Installation of kenmore furnace and air conditioner

Rheem ac repair inspection maintenance tuneup

Furnace repair, humidifier repair, boiler repair, boiler maintenance, humidifier maintenance , furnace maintenance